Hello again

Pat M

Active member
Gentlemen,

I have been gone from this forum for a while but happy to be back and catching up on all the great information you guys have to post. Last year I needed to replace the transom on my broadbill and after pulling the floor realized I need to replace all of the supports. Unfortunately I didn't take too many pictures during the rehab. I got it finished before the season and got it out for a few hunts. The summer was crazy busy and the season is a upon us here in Wisconsin but I am going to try to get a dodger built still too. I have an older 15hp to run in bigger/deeper water and a small 6 hp mud motor for the skinny stuff. I am also in the process of building a 16hp mud motor to put on her as well. Trying to figure out what shaft length I want for the motor.

Rehab Picture
https://drive.google.com/...k5J/view?usp=sharing


Pictures of the boat
https://drive.google.com/...Tjg/view?usp=sharing
https://drive.google.com/...NkE/view?usp=sharing
https://drive.google.com/...RVE/view?usp=sharing


 
Last edited:
Back
Top