Andrew Holley
Well-known member
So I am going to sand blast and paint an old jointer I have been using for a long time. I want to remove and re attach the name plates once I am done, how?
Grinder is to error prone, thinking a small chisel will remove the rivet, then drill the remaining portion out, do my clean up and then rivet it back together, however, where do I get rivets? These aren't pop rivets from a hardware store, solid?
Will attach photos later if I can figure that out now that I no longer have a photobucket account.
Thanks
Grinder is to error prone, thinking a small chisel will remove the rivet, then drill the remaining portion out, do my clean up and then rivet it back together, however, where do I get rivets? These aren't pop rivets from a hardware store, solid?
Will attach photos later if I can figure that out now that I no longer have a photobucket account.
Thanks