Duckboats.net
Skip to Content


Home : Main Forums : Duck Boat/Hunting Forum :

Transducer mount

Quote Reply
Transducer mount
Took duckin around out this weekend for her maiden voyage, noticed the depth finder I got with the boat only works when I?m going really slow, or sitting at idle. And when I mean really slow, I mean not even really moving. I took a look at the transducer and looks like it should mounted be a little lower And to the starboard another few inches to get away from the lifting strake, but was looking for opinions from more experienced folks.
Quote Reply
Re: Transducer mount In reply to
I would encourage you to move it closer to the centerline and lower than the lifting pad. Essentially you will want you transducer to be mounted in the laminar flow, absent cavitation bubbles.., and vertical if you are operating in deep water, unlike its current mount position. If you move outboard, you will lose your signal when you turn hard to port.

There are a number of King starboard pads that epoxy to a base with multiple indents to maximize surface area adhesion-nothing adheres well to .starboard.

Also, place those mushrooms growing in your wood chips gill side down on a covered paper plate overnight. If the spore print is a light chocolate brown, physically bruise the gill tissue and wait fifteen minutes to determine what color it shifts to from almond white/pink. If there is no color change or pinkish; pretty sure those may be Agaricus campestris I picked a couple of gallons (7-10) of oyster mushrooms (Pluerotus ostreatus) yesterday along with about forty wild strawberries to go with the trout I caught this morning...life is good in quarantine! Wild strawberries are about an inch diameter, but like wild blueberries the flavor is quite intense.
Quote Reply
Re: Transducer mount In reply to
Yep, gotta get lower, way lower. Bottom of the transducer need to be in clean water, below the bottom of the hull. Makes it tough when you bottom out the boat at low tide, make sure the mount will pivot up.

And away from the strake, I'd move it towards the center if you can.


Carl
Mobile, AL
DHBP Member since 1998

"Life is too short to drink bad beer."
Disclaimer: This post and/or report is not a substantiation of or reflection on the true accuracy of the present surveying methods. It is only a report on or comment concerning local observation and/or results. Your results and observation may vary based on your location, local water conditions, food supply, weather conditions and migratory patterns "
Quote Reply
Re: Transducer mount In reply to
Will do. So maybe 4 inches to port? Here?s a photo with the motor on there. Didn?t know it could get so close
Quote Reply
Re: Transducer mount In reply to
Nick,
Here is some general guidelines. It should be just below the hull and mounted on the same plane as the hull (bow to stern). I usually use a straight edge. I would say yes on the 4? to port possibly more.



Gunning from the FOWL HOOKED

Last edited by:

T Entwistle: Jun 30, 2020, 5:43 PM