Bob Collier
Active member
Sorry guys but I am baffled?
My season ended a little early last year do to a rock punching a hole in my hull in November.
Boat went into the garage, and I noticed during the off season the lower unit was leaking so changed out the seal and refilled the gear case and patched the hole in the hull ( thanks to a lot of help and advice from the great members on DuckBoats.net! )
Took it out today and it will not plane out!! Nothing changed as far as the set up.
40 hp Evinrude tiller, Panther trim/tilt unit on a Duck Wrangler 15' fiberglass hull.
Motor seems to be running smooth, tried adjusting the motor under power with no change. It is not cavitating just will not plane out at WOT, worked fine when I closed out the season?
Any thoughts?
Thanks in advance
Bob
My season ended a little early last year do to a rock punching a hole in my hull in November.
Boat went into the garage, and I noticed during the off season the lower unit was leaking so changed out the seal and refilled the gear case and patched the hole in the hull ( thanks to a lot of help and advice from the great members on DuckBoats.net! )
Took it out today and it will not plane out!! Nothing changed as far as the set up.
40 hp Evinrude tiller, Panther trim/tilt unit on a Duck Wrangler 15' fiberglass hull.
Motor seems to be running smooth, tried adjusting the motor under power with no change. It is not cavitating just will not plane out at WOT, worked fine when I closed out the season?
Any thoughts?
Thanks in advance
Bob