David Clites
Active member
Hi All,
These galvanized steel handles don't last very long because they are constantly submerged then dried off, submerged again. I do rinse after any saltwater hunt, but pressed steel design traps water.
Does anybody know a good source for Stainless, or Silicon Bronze or Brass, even make them out of Teak, Black Locust, Osage Orage, etc? Ideally the 4 holes in each of the 2 handles would line up with existing holes which are on 1inch x 5.5inch spacing. Photos in 2nd post (my cellphone camera doesn't link with my laptop).
Thanks for any input.
These galvanized steel handles don't last very long because they are constantly submerged then dried off, submerged again. I do rinse after any saltwater hunt, but pressed steel design traps water.
Does anybody know a good source for Stainless, or Silicon Bronze or Brass, even make them out of Teak, Black Locust, Osage Orage, etc? Ideally the 4 holes in each of the 2 handles would line up with existing holes which are on 1inch x 5.5inch spacing. Photos in 2nd post (my cellphone camera doesn't link with my laptop).
Thanks for any input.