Well, I could not help myself. While I was sitting in the boat contemplating how I am going to do my Dodger. I thought screw it, I'm just going to cut this seat out, if I have to do a some glassing I'll just have to do some glassing hehe!
I am glad I cut it out, I don't really think it was offering much support. The wood and foam were completely water logged. Most of the wood was falling apart and wasn't even attached to the glass it just pulled out.
I think I am going cut it as flush as I can and then do a little sanding to smooth out the ruff edges. Any suggestions on what sand paper or tool I should used to smooth the edge out with?
So here we are!
I am glad I cut it out, I don't really think it was offering much support. The wood and foam were completely water logged. Most of the wood was falling apart and wasn't even attached to the glass it just pulled out.
I think I am going cut it as flush as I can and then do a little sanding to smooth out the ruff edges. Any suggestions on what sand paper or tool I should used to smooth the edge out with?
So here we are!
Last edited: