Search results

Back the trailer in the water just past the top of the fenders and drive it till it bumps the roller reach over the bow while it’s idling in gear and crank it up tight done .... with a 13.5x17 prop I’m getting 38 with slight opposing past 34 ish... I’m gonna switch to a 4 blade prop to help the...

I post more when I’m done wiring and plumbing

No I use a nonferrous skill saw blade ... I cut the whole boat with the skill saw...what ever tools you use for wood you can use on aluminum.... planers , routers,table saws,jigsaws and so on

After the floor is fitted you have already marked the location of your subfloor and you cut with a skill saw with 2 blades on it

Sounds good ... I should be done soon

Floor in

Self bailing bungs wash down pump and bilge pump bungs installed

this was the first rodeo

Potentially I live in astoria Oregon

I’m hoping it will only draft 9 inches per the plans

The big stuff I have a few buddies hold while I tack... the small stuff clamps or by hand.... this is my progress with 2.5 week ends into it.... I’m hoping to be done befor April 1st.... that’s correct I welded all the watertight compartments inside and out and below the waterline fully inside...

Scupper valve

I’m hoping for around 38 knots